OuterU FACEGLOVE HIGHLOFT

The standard for ski patrol officers and guides on Everest, Denali, and Antarctica

faceGlove® is a premium model made from POLARTEC high-loft material and custom molded to protect the most sensitive areas of your face without restricting breathing.

Combine with stretch tubing from Bala or Buff to create a smarter face protection system that keeps your goggles fogging up and keeps you focused.

It also comes with a head strap and ear loops, so you can choose whichever fits best for you.

*Included accessory ① Head strap: Use in place of the ear loop.
*Included ② Elastic cord (approximately 1m): This is a multi-purpose cord that can be used as a replacement string or for hanging around the neck. When using it as a neck strap, insert it into the ear loop hole from the front of the device and tie it to the ear loop string on the inside. Adjust the length to your liking.

Size details

SIZE CHART

Before warming up your FaceGlove, please read the following:
* Immediately after heating, hold the ear loops, not the FaceGlove itself. Holding the body may cause molding failure.

What you will need: FaceGlove, goggles, helmet, 2 coffee mugs, timer, mirror.

1. Thoroughly wet the fleece lining of the molded part inside the main body (the hard part at the bottom of the main body). Wipe off any excess water.

2. Roll the dough into a ball, place it in a mug, and cover the mug with plastic wrap. Make 2-3 holes in the plastic wrap.

3. Heat at 500W for 35 seconds.

4. Remove the FaceGlove from the mug, being careful not to burn yourself, and ensure the molded parts are sufficiently soft.
*If it is hard, wet it again and heat it for 30 seconds. Repeat this process until it becomes soft.

5. Put on the FaceGlove and adjust it so that it is centered on your face while looking in the mirror.

6. Put on your helmet and goggles slowly and carefully, making sure the FaceGlove is not in place.

7. Use your thumbs to bring the FaceGlove closer to your nose, and adjust it so that it is not too tight. Ideally, there should be a trapezoidal gap around your nose.

8. Wait 1 minute 30 seconds.

9. Carefully remove the molded parts, making sure they have hardened. To avoid mistakes, remove them without touching the nose part.

10. Gently fold the FaceGlove in half and place it between the mugs to maintain its shape. Let it sit for 5 minutes.

If it fails, repeat steps 3-10.

*The fabric of the product stretches up to the top of the nose so that it can be worn with sunglasses. However, if you plan to only wear goggles, you can cut the fabric if it gets in the way.
*Please be careful not to get burned when molding. outerU and its distributors will not be held responsible for any burns.

Product specifications

PRODUCT SPEC

- Material: Polartec High Pile Fleece
- Weight: 11g

Care methods and precautions

PRODUCT CARE

- Hand wash in cold water
- When doing so, please wash gently to avoid damaging the molded parts.